View source for Installing OpenSTLinux on VisionSOM-STM32MP1 with SD card

{{PageHeader|Installing OpenSTLinux on VisionSOM-STM32MP1 with SD card}}

The built system image file can be written to the SD card using the following command:

<pre>
sudo dd if=<image .raw file> of=/dev/sdX bs=1M
</pre>

The ''/dev/sdX'' shall be changed according to the SD card device name.

In order to run the images from SD card the main board jumpers shall be set as follows (BOOT[0:2] = 101):

[[File:Stm32mp1_sd_boot_jumpers.png|center|300px]]