Programming eFUSE bits on VisionSOM-6ULL: Difference between revisions
From SomLabs Wiki
Created page with "{{PageHeader|Programming eFUSE bits on VisionSOM-6ULL}} {| class="frame-green" |- |'''NOTE!''' The described operation may be performed only once and cannot be reversed! |}..." |
(No difference)
|
Revision as of 13:18, 12 May 2020
Programming eFUSE bits on VisionSOM-6ULL
| NOTE! The described operation may be performed only once and cannot be reversed! |
This article describes the programming eFUSE on VisionSOM-6ULL with VisionCB-6ULL-STD. It requires the UUU tool that may be downloaded from here.
1. Enable the eFUSE boot mode by setting the BOOT[1:0] signals to 00. 2. Connect the VisionCB-6ULL-STD board to the PC using the USB-OTG connector. 3. Power-on the board - the processor will starts in the serial downloader mode because the eFUSEs are not yet programmed. 4. Run the downloaded UUU tool:
On Windows:
uuu.exe vsom_6ull_fuse_sd_boot.lst
On Linux:
./uuu vsom_6ull_fuse_sd_boot.lst
5. Reset the board - if the SD card is inserted, the system will automatically boot.
