VisionCB-6ULL-STD: Difference between revisions
From SomLabs Wiki
No edit summary |
No edit summary |
||
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
{{Product|category1=SOM|category2=|image=VisionCB-STD-1-4-1k.png | {{Product|category1=SOM|category2=|image=VisionCB-STD-1-4-1k.png | ||
|cb_som_compatibility= | |cb_som_compatibility=VisionSOM-6UL and VisionSOM-6ULL module with NXP i.MX6ULL processor | ||
|cb_som_socket= | |cb_som_socket=SODIMM200 | ||
|cb_display_connector= | |cb_display_connector=24-bit RGB parallel interface (FPC50) | ||
|cb_network= | |cb_network=1x Ethernet 10/100Mbit/s, RJ45 | ||
|cb_usb= | |cb_usb=USB 2.0 host x1, USB-OTG 2.0 x1 | ||
|cb_debugger= | |cb_debugger=JTAG connector for external debugger | ||
|cb_console_interface= | |cb_console_interface=USB/UART | ||
|cb_switches= | |cb_switches=4+1 (reset) | ||
|cb_leds= | |cb_leds=4 + 1 (power) | ||
|cb_connectors= | |cb_connectors=Raspberry Pi compatible (40 pins, 2,54mm), Arduino Rev3 | ||
|cb_rtc_backup= | |cb_rtc_backup=none | ||
|cb_power_supply= | |cb_power_supply=External 9-12V DC | ||
|temp= 0 to +70°C | |temp= 0 to +70°C | ||
|dim=130mm x 90mm x 17mm | |dim=130mm x 90mm x 17mm | ||
Latest revision as of 08:53, 7 April 2020
| VisionCB-6ULL-STD |
|
VisionCB-6ULL-STD is a carrier board for the VisionSOM family of computer-on-modules which are powered by NXP i.MX 6UL or i.MX 6ULL application processors (ARM Cortex-A7). A carrier board, together with a System on Module (SoM), makes a complete development platform similar to SBC. The carrier board houses the most common interfaces such as USB, Ethernet, UART, etc. A large variety of interfaces allows to use it as both a complete development platform or as a stand-alone end-product. |
Documentation
| Specifications |
| SOM compatibility | VisionSOM-6UL and VisionSOM-6ULL module with NXP i.MX6ULL processor |
| SOM socket | SODIMM200 |
| Display connector | 24-bit RGB parallel interface (FPC50) |
| Network | 1x Ethernet 10/100Mbit/s, RJ45 |
| USB | USB 2.0 host x1, USB-OTG 2.0 x1 |
| Debugger | JTAG connector for external debugger |
| Console interface | USB/UART |
| Switches | 4+1 (reset) |
| LEDs | 4 + 1 (power) |
| Connectors | Raspberry Pi compatible (40 pins, 2,54mm), Arduino Rev3 |
| RTC Backup | none |
| Power supply | External 9-12V DC |
| Temperature Range | 0 to +70°C |
| Dimensions | 130mm x 90mm x 17mm |
