Programming eFUSE bits on VisionSOM-6ULL
From SomLabs Wiki
Revision as of 16:09, 29 September 2020 by KrzysztofChojnowski (talk | contribs)
Programming eFUSE bits on VisionSOM-6ULL
| NOTE! The described operation may be performed only once and cannot be reversed! |
This article describes the programming eFUSE on VisionSOM-6ULL with VisionCB-6ULL-STD. It requires the UUU tool that may be downloaded from .
Programming iMX6ULL OTP fuses with u-boot
If board is already programmed, stop it during boot in u-boot bootloader by pressing a key when prompted.
To write fuse, use one of the following u-boot commands:
- Command to configure VisionSOM-6ULL to boot from on board uSD card:
fuse prog -y 0 5 0x2840 fuse prog -y 0 6 0x10
- Command to configure VisionSOM6ULL to boot from on board eMMC memory:
fuse prog -y 0 5 0x2860 fuse prog -y 0 6 0x10
If device is not programmed yet, you can use serial download mode, as described here: [Writing_VisionSOM-6ULL_system_image_to_eMMC_memory] and then program fuses.
Programming iMX6ULL OTP fuses with UUU tool
It is also possible to program OTP fuses via NXP manufacturing tool (uuu) For details see the manual in attached archive.
